Flush the end of the flashing length with the wall corner and secure the flashing to the framing with an 8d nail at each wall stud.
Z bar flashing installation.
The large leg of the metal goes against the wall leaving the seat and face covering the top edge of the siding.
Z bar design easily accommodates rigid insulation.
It is used to protect the horizontal joints between sheets of siding from water infiltration.
Check out our recommended tools right here.
Subject to inquiry for availability.
The z bar is available in 018 033 043 054 thickness of steel.
Window and door cap 1 25 in x 120 in x 1 56 in aluminum z flashing.
Backleg made of 28 gauge galvanized steel.
When installing the flashing the longer edge goes against the wall of the house the center section rests on top of the casing and the.
If only the surface is damaged.
Galvanized steel z flashing is made from 28 gauge galvanized steel.
Z bar flashing provides an inexpensive and easy to install method of stopping water penetration behind siding.
Bailey s z bars are ideal for many construction applications such as continuous framing insulation reinforcement slides track and roofing.
Thd sku 686080.
How to install z flashing on rotted t1 11 siding 1.
Flanges are available in lengths of 1 1 1 1.
Galvanized steel unless specified.
Steel z bar flashing with 2 in.
Begin at either end of the wall and set the level middle section of the z flashing onto the top edge of the siding panel with the wider flange upward and against the wall framing.
Suitable for residential or commercial use.
Designed for roofing applications.
Item 3807 model 5504900120.
Test the rotted area of the t1 11 siding by poking it with a nail or a screwdriver.
Scrape loose paint off the rotted area with a putty knife and use 80 grit sandpaper to smooth the rough surface if.
